Digimerge DH100 Series Instrukcja Obsługi Pobierz pdf (Strona 128)

116

Appendix J: Replacing the Hard Drive

APPENDIX J: REPLACING THE HARD DRIVE

The system comes with a pre-installed 3.5" SATA hard drive. You can install up to one 1.5TB hard

drive.

NOTE: Mak

e sure that the system is

OFF

and the power cable has been disconnected before

changing the hard drive.

Removing the Hard Drive

To remove the hard drive:

1. Power off the system, and unplug all wiring / cabling from the system.

2. Remove the two (2) short screws on the side panels

of the housing and the three (3) short

screws on the rear panel. Keep these sets of screws separate.

*8-channel model shown

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 139 140

Brak uwag

Digimerge DH100 Series Instrukcja Obsługi Strona 128